diff --git a/README.md b/README.md
index b18ccf2..cf8974b 100644
--- a/README.md
+++ b/README.md
@@ -1,3 +1,67 @@
 # RNode Configuration Utility
 
-Configure, flash, backup and upgrade your RNode with this handy utility.
\ No newline at end of file
+## Intro
+
+Configure, flash, backup and upgrade your RNode with this handy utility. The only required option is the serial port the device is attached to. To show basic device info, use the -i option.
+
+RNode can operate in two modes, host-controlled (default) and TNC mode:
+
+- When RNode is in host-controlled mode, it will stay in standby when powered on, until the host specifies frequency, bandwidth, transmit power and other required parameters. This mode can be enabled by using the -N option of this utility.
+
+- When RNode is in TNC mode, it will configure itself on powerup and enable the radio immediately. This mode can be enabled by using the -T option of this utility.
+
+For a complete description of RNodes capabilities, documentation and more, please refer to the [RNode repository](https://github.com/markqvist/RNode_Firmware).
+
+```
+usage: rnodeconf.py [-h] [-i] [-T] [-N] [-b] [-d] [-f] [-r] [-u] [-k] [-p]
+                    [--model model] [--hwrev revision] [--freq Hz] [--bw Hz]
+                    [--txp dBm] [--sf factor] [--cr rate]
+                    [port]
+
+RNode Configuration and firmware utility. This program allows you to change
+various settings and startup modes of RNode. It can also flash and update the
+firmware, and manage device EEPROM.
+
+positional arguments:
+  port              serial port where RNode is attached
+
+optional arguments:
+  -h, --help        show this help message and exit
+  -i, --info        Show device info
+  -T, --tnc         Switch device to TNC mode
+  -N, --normal      Switch device to normal mode
+  -b, --backup      Backup EEPROM to file
+  -d, --dump        Dump EEPROM to console
+  -f, --flash       Flash firmware and bootstrap EEPROM
+  -r, --rom         Bootstrap EEPROM without flashing firmware
+  -u, --update      Update firmware
+  -k, --key         Generate a new signing key and exit
+  -p, --public      Display public part of signing key
+  --model model     Model code for EEPROM bootstrap
+  --hwrev revision  Hardware revision EEPROM bootstrap
+  --freq Hz         Frequency in Hz for TNC mode
+  --bw Hz           Bandwidth in Hz for TNC mode
+  --txp dBm         TX power in dBm for TNC mode
+  --sf factor       Spreading factor for TNC mode
+  --cr rate         Coding rate for TNC mode
+```
+
+## Dependencies
+
+The config utility requires Python 2.7, pyserial and cryptography.io. To install:
+
+```
+sudo apt install python
+sudo pip install pyserial cryptography
+```
+
+## Installation
+
+Just clone or download this repository, place wherever you'd like and run rnodeconf (remember to set executable permissions):
+
+```
+git clone https://github.com/markqvist/rnodeconfigutil.git
+cd rnodeconfigutil
+chmod a+x rnodeconf
+./rnodeconf --help
+```
\ No newline at end of file
diff --git a/rnodeconf.py b/rnodeconf
similarity index 100%
rename from rnodeconf.py
rename to rnodeconf