1.6 KiB
Building on Raspberry Pi
Turn your Pi into a pretty okay-ish travel router (or a very slow main router)!
OpenWrt officially supports Raspberry Pi hardware if you want to run it as your OS. But running in a container brings many advantages, one of which is not having to re-flash your SD card.
This has been tested on a Raspberry Pi Zero W running Raspbian Lite, but should work for other versions too. Just make sure you download the right image for your Pi version (refer to the notes in build-rpi.sh).
IPv6
By default Raspbian does not load the kernel module for IPv6 iptables on boot.
Run sudo modprobe ip6_tables to load it immediately.
To persist on reboot, run
$ echo 'ip6_tables' | sudo tee /etc/modules-load.d/ip6-tables.conf
Build
You can build the OpenWRT docker image on the Pi itself, or on your x86 PC with qemu-arm installed.
First download and extract the OpenWRT factory image for your Pi. Refer to the OpenWrt Table of Hardware to choose the right image. Then run the make target.
The variable RPI_SOURCE_IMG can be specified in openwrt.conf or on the command line:
$ wget https://downloads.openwrt.org/releases/19.07.2/targets/brcm2708/bcm2708/openwrt-19.07.2-brcm2708-bcm2708-rpi-ext4-factory.img.gz
$ gzip -d openwrt-*.img.gz
$ make build-rpi RPI_SOURCE_IMG=openwrt-19.07.2-brcm2708-bcm2708-rpi-ext4-factory.img
If you built the image on your PC, send it to your Raspberry Pi ($BUILD_TAG is a config variable):
$ docker save $BUILD_TAG | ssh <your_raspberry_pi_host> docker load